Справочник Пользователя для Mitsubishi Electronics FR-A700

(Setting dial: Mitsubishi inverter 
dial)

Used to change the 
frequency setting and 
parameter settings.

Used to switch between the PU and External operation mode.
When using the External operation mode (operation using a separately 
connected frequency setting potentiometer and start signal), press this key to 
light up the EXT indicator. (Change the Pr.79 value to use the combined mode.)
PU:  PU operation mode
EXT: External operation mode

Shows the frequency, parameter 
number, etc.

Lit to indicate monitoring mode.

PU:  Lit to indicate PU operation mode.
EXT: Lit to indicate External operation mode.
NET: Lit to indicate Network operation mode.

REV: Lit when reverse rotation

FWD: Lit when forward rotation

Stop operation
Used to stop Run 
command.
Fault can be reset when 
protective function is 
activated (fault).

Used to change 
each setting mode.

· 

Hz: Lit to indicate frequency.

· 

A:  Lit to indicate current.

· 

V:  Lit to indicate voltage.

(Flicker when the set frequency monitor is 
displayed.)

*  Energy saving monitor is displayed when the 

energy saving monitor of Pr. 52 is set.

Used to set each setting.
If pressed during operation, monitor 
changes as below.

Running 

frequency

Output 

current

Output 

voltage

On: Forward/reverse 

operation

Flickering:  When the frequency command is 

not given even if the 
forward/reverse command is given.

                     When the MRS signal is input.

*