Справочник Пользователя для Standard Horizon CP180i

  

CP180 / CP180i

Page 15

1. Remove the threaded base from the antenna dome.
2. To ease installation a flush mounting template for the antenna has been included.
3. Apply the mounting template sticker to the area that was verified for GPS reception.
4. Then, drill out the 0.63” (16mm) and 0.16” (4mm) holes, and remove the template.
5. Insert the cable into the 0.63” (16mm) hole and route to the GPS chart plotter.
6. Apply a small amount or RTV to the under side of the antenna.
7. Place the antenna and then screw it into place using the screws. In some cases the

screw may not be long enough, if this happens simply apply more RTV to the underside
of the antenna to glue it into place.

Figure 2.3.0 -  Installing the GPS WAAS Smart antenna (I)

GPS OVERALL SHAPE

CUTTING TEMPLATE

CUTTING TEMPLATE

4 mm [0.155"]

4 mm [0.155"]

0

0

16 mm [0.63"] or greater

0

0

4 mm [0.155"]

Figure 2.3.0a -  Installing the GPS WAAS Smart antenna  (II)

2.4

CONNECTIONS

The CP180 or CP180i has connectors that are used to connect to the power supply, GPS
antenna (CP180 only) optional FF520 Fish Finder and to NMEA devices such as Marine

VHF radio

, digital instruments, autopilots and AIS receivers.

NOTE

The GPS chart plotter can send many sentences to external NMEA devices. The NMEA output wires

are Yellow, Brown and White.

 If you have connected devices as shown in the below table and need

to feed NMEA to other devices (Autopilot, RADAR…) you can parallel wires from the 

Yellow, Brown

or White wires.

2.4.0 Connection Table

1

Black

Battery Ground

Connect to Battery Ground

2

Red

Battery Positive

Connect to Battery Positive

3

Green

NMEA Common

Common for NMEA devices

4

Blue

Port1 Input

Connect to Output of NMEA device

Default is NMEA0183

5

Brown

Port1 Output

Connect to Input of NMEA device

Default is NMEA0183 with GLL, RMB, RMC
and XTE sentences