Справочник Пользователя для Smeg AP91VJME

Скачать
Страница из 29
 
 
Instruction for the installer 
 
7
 
 
 
2.1  Electrical connection 
 
   
 
  Make sure that the power line voltage matches the specifications indicated on the rating plate located 
inside the storage compartment.  
This rating plate must never be removed. 
 
   
 
  If the appliance is hooked-up to the supply by means of a fixed connection, install a multipolar cut-out 
device on the line, with contact opening distance equal to or greater than 3 mm, located near the 
appliance and in an easily reachable position. 
 
   
 
  Hook-up to the supply may be fixed or with plug and socket. In the latter case the plug and socket 
must be suitable for the cable employed and conform with the regulations in force. Regardless of the 
type of connection, earthing of the appliance is absolutely obligatory. Before connection make sure 
that the supply line is suitably earthed. Avoid the use of reducers, adapters or shunts.1 
 
   
 
  If the power cable is replaced, the wire section on the new cable must 
not be less than 1.5 mm
2
 (3 x 1.5 cable), keeping in mind that the end 
to be connected to the hob must have the ground wire (yellow-green) 
longer by at least 20 mm. Use only H05V2V2-F cable or similar which 
has a maximum temperature of 90°C. This must be done by a 
specialised technician, who must connect the cooker to the electricity 
supply according to the diagram shown here. 
L = brown 
N = blue 
 = yellow-green. 
 
   
 
 
2.2  Ventilation requirements 
 
   
 
  The room containing the appliance should have an air supply in accordance with B.S. 5440 part 2 
1989. 
1.  All rooms require an opening window or equivalent, and some rooms will require a permanent 
vent as well. 
2.  For room volumes up to 5 m
3
 an air vent of 100 cm
2
 is required. 
3.  If the room has a door that opens directly to the outside, and the room exceeds 1 m
3
no air vent is 
required. 
4.  For room volumes between 5 m
3
 and 10 m
3
 an air vent of 50 cm
2
 is required. 
5.  If there are other fuel burning appliances in the same room B.S. 5440 part 2 1989 should be 
consulted to determine the air vent requirements. 
6.  This appliance must not be installed in a bed sitting room of less than 20 m
3
 or in a bathroom or 
shower room. 
Windows and permanent vents should therefore not be blocked or removed without first consulting a 
Corgi gas installer. 
Failure to install appliances correctly is dangerous and could lead to prosecution.