Справочник Пользователя для Beko GNE V320 B
EN
7
3
Installation
C
Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.
the information given in the instruction
manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be
emptied and cleaned prior to any
transportation.
transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
securely by adhesive tape against any
jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
rules of transportation printed on the
package must be followed.
C
Always remember...
Every recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1. Is the interior of the refrigerator dry
check the following:
1. Is the interior of the refrigerator dry
and can the air circulate freely in the
rear of it?
rear of it?
2. Clean the interior of the refrigerator as
recommended in the “Maintenance
and cleaning” section.
and cleaning” section.
3. Plug the refrigerator into the wall
outlet. When the door is open the
respective interior light will come on.
respective interior light will come on.
4. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
5. Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
areas are designed to be warm to
avoid condensation.
Electric connection
Connect your refrigerator to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
fuse with the appropriate capacity.
Important:
B
The connection must be in
compliance with national regulations.
B
The power cable plug must be easily
accessible after installation.
B
Voltage and allowable fuse protection
are specified in the “Technical
Specifications” section.
Specifications” section.
B
The specified voltage must be equal
to your mains voltage.
B
Extension cables and multiway plugs
must not be used for connection.