Справочник Пользователя для Mitsubishi Electronics MR-385R-ST-A

(1) Detach the drain pan.

(2) Collect gas from the charge pipe on the high pressure side.
(3) After collecting gas, cut the charge pipe on the low pressure side.
(4) Detach the welded section of the discharge pipe and suction pipe
(5) Replace the compressor and the dryer at a time. (The dryer should be the one packed with the compressor.)

After replacement check cooling operation and check the weld for gas leaking.

- 22 -

Suction pipe

Binder

Dryer

Discharge pipe

(High pressure side)

U Washer

Charge pipe

: This mark shows welding point.