Справочник Пользователя для KitchenAid BUILT-IN REFRIGERATOR

■

Remove tape and glue residue from surfaces before turning 
on the refrigerator. Rub a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water 
and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your refrigerator. For 
more information, see “Refrigerator Safety.”

After you remove all of the packaging materials, clean the inside 
of your refrigerator before using it. See the cleaning instructions 
in “Refrigerator Care.”

Read all directions carefully before you begin.

■

When your refrigerator was installed, the water connection 
from the water source should have been connected to your 
refrigerator. If your refrigerator is not connected to a water 
source, see “Connect the Water Supply” in the Installation 
Instructions. If you have any questions about your water 
connection, see “Troubleshooting” or call a licensed, qualified 
plumber.

■

If you turn the refrigerator on before the water line is 
connected, turn the ice maker OFF. See “Ice Maker and 
Storage Bin.”

■

All installations must meet local plumbing code requirements.

A cold water supply with water pressure between 30 and 120 psi 
(207 - 827 kPa) is required to operate the water dispenser and ice 
maker. If you have questions about your water pressure, see 
“Troubleshooting” or call a licensed, qualified plumber.

IMPORTANT: The pressure of the water supply coming out of a 
reverse osmosis system going to the water inlet valve of the 
refrigerator needs to be between 30 and 120 psi (207 - 827 kPa).

If a reverse osmosis water filtration system is connected to your 
cold water supply, the water pressure to the reverse osmosis 
system needs to be a minimum of 40 to 60 psi (276 - 414 kPa).

If the water pressure to the reverse osmosis system is less than 
40 to 60 psi (276 - 414 kPa):

■

Check to see whether the sediment filter in the reverse 
osmosis system is blocked. Replace the filter if necessary.

■

Allow the storage tank on the reverse osmosis system to refill 
after heavy usage.

■

If your refrigerator has a water filter cartridge, it may further 
reduce the water pressure when used in conjunction with a 
reverse osmosis system. Remove the water filter cartridge. 
See “Water Filtration System.”

If you have questions about your water pressure, call a licensed, 
qualified plumber.

If you need to turn the power to your refrigerator ON or OFF, you 
must remove the top grille assembly to access the On/Off switch. 
Turn the power to the refrigerator OFF when cleaning product or 
changing light bulbs.

Do not clean glass shelves or covers with warm water when 
they are cold. Shelves and covers may break if exposed to 
sudden temperature changes or impact, such as bumping. 
For your protection, tempered glass is designed to shatter 
into many small, pebble-size pieces. This is normal. Glass 
shelves and covers are heavy. Use special care when 
removing them to avoid impact from dropping.