Справочник Пользователя для U-Line U-CO298-00
u-line.com
3
Air Flow
NOTICE
The unit requires proper air flow to perform at its highest
efficiency. Do not block the front grille or internal fans at
any time, or the unit will not perform as expected. Do not
install the unit behind a door.
efficiency. Do not block the front grille or internal fans at
any time, or the unit will not perform as expected. Do not
install the unit behind a door.
Initial Startup
All U-Line controls are preset at the factory. Initial startup requires
no adjustments.
no adjustments.
NOTICE
U-Line recommends allowing the unit to run overnight
before loading refrigerator or freezer with product.
before loading refrigerator or freezer with product.
NOTICE
On ice maker equipped units, it is possible that dirt or
scale will dislodge in the water line. Always throw away all
ice cubes made during the first two to three hours of
operation.
scale will dislodge in the water line. Always throw away all
ice cubes made during the first two to three hours of
operation.
To turn the unit on or off:
Press the rocker switch located below the temperature control
dial in the center of the grille (2), inside the door on the front
panel, or behind the grille.
dial in the center of the grille (2), inside the door on the front
panel, or behind the grille.
Control Dial
Combo Models provide two temperature zones within the cabinet
to satisfy the specific storage requirements.
to satisfy the specific storage requirements.
The control dial sets a single continuous temperature. This set-
point temperature is a base setting used by the controller to
maintain the temperature zone in the unit. The factory default MID
setting, number 3 or 4 set-point, for Beverage Center and
Refrigerator models is 38°F. The factory default set-point for Wine
Captain models is 50°F. The set-point temperature is a gauge for
further temperature adjustments.
point temperature is a base setting used by the controller to
maintain the temperature zone in the unit. The factory default MID
setting, number 3 or 4 set-point, for Beverage Center and
Refrigerator models is 38°F. The factory default set-point for Wine
Captain models is 50°F. The set-point temperature is a gauge for
further temperature adjustments.
Product Operation
OFF
ON