Инструкции Пользователя для Frigidaire FHWC3655LS
9
GB
fig.
fig.
fig.
Electrical connections
DANGER
Danger of electric shock! All fittings must be
installed by a competent person in accordance
with current wiring regulations and local
building regulations. If in doubt, consult a
qualified electrician.
installed by a competent person in accordance
with current wiring regulations and local
building regulations. If in doubt, consult a
qualified electrician.
IMPORTANT
Always switch off the electricity supply at
the mains during installation, cleaning and
maintenance. We recommend that the fuse is
withdrawn or circuit breaker switched off at the
distribution board while work is in progress.
the mains during installation, cleaning and
maintenance. We recommend that the fuse is
withdrawn or circuit breaker switched off at the
distribution board while work is in progress.
Step 5:
• Loosen the 2 short screws from the junction box
• Loosen the 2 short screws from the junction box
(fig. ).
fig.
fig.
• Connect the incoming positive, neutral and
ground cables to the respective terminals. The
ground cable is already pre-assembled onto the
junction box to provide grounding (fig. ).
ground cable is already pre-assembled onto the
junction box to provide grounding (fig. ).
fig.
L (live) = Black
(ground) = Green
N (neutral) = White
L
N
• Mount the junction box onto the range hood
using 2 short screws (15) (fig. ).
fig.
Step 6:
• Insert the upper chimney (3) into the lower chimney
• Insert the upper chimney (3) into the lower chimney
(3) from top to bottom (fig. ).
• Mount upper and lower chimney (3) on the range
hood (1). Fit the tab, which is bend by 90 degrees,
into the lower bracket notch and mount to the lower
bracket (5) (fig. / ).
into the lower bracket notch and mount to the lower
bracket (5) (fig. / ).
• Pull the upper chimney (3) to the upward position to
match the screw hole of the upper bracket. Mount to
the upper bracket (4) with 2 side screws (12) (fig. ).
the upper bracket (4) with 2 side screws (12) (fig. ).
fig.
fig.
fig.
fig.
fig.
fig.
• Insert 2 screws (10 or 14) in the top location, but
do not fully insert the screws (fig. ). Mount the
range hood (1) to the wall and tighten the screws.
Insert and tighten the 2 remaining screws on the
bottom location of the range hood (fig. / ).
range hood (1) to the wall and tighten the screws.
Insert and tighten the 2 remaining screws on the
bottom location of the range hood (fig. / ).
• Attach the collar (6) to the range hood (1). Secure
with 2 short screws (12) (fig.
).
Step 3:
• Mount the glass cover (2) onto the range hood
• Mount the glass cover (2) onto the range hood
(1). Use the allen key (13) to secure with 4 sets of
bolts, rubber washers, and washers (9) (fig. ).
bolts, rubber washers, and washers (9) (fig. ).
Step 4:
• Mount upper and lower brackets (4, 5) on the
• Mount upper and lower brackets (4, 5) on the
wall. Secure with the remaining 4 sets of long
screws (10). The notches of the lower bracket
should be facing up towards the ceiling (fig. ).
screws (10). The notches of the lower bracket
should be facing up towards the ceiling (fig. ).
• Attach the exhaust duct (fig. ).
Installing the hood
Installing the hood
00-Elux FHWC3060LSA-Range hood-Book-01.indd 9
12/8/10 12:43 PM