Справочник Пользователя для Hoshizaki KMS-1401MLJ

36

Scale may build up on BC. Scale can cause the actuator paddle and magnet to stick. In 
this case, BC should be cleaned.

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are 
securely in place after the icemaker is serviced. Make sure that none have fallen 
into the dispenser unit/storage bin.

1) Turn off the power supply.
2) Remove the front panel, then move the 

control switch to the "OFF" position.

3) Remove the top and right side panels. 

Remove the control box cover, then clear 
any ice away from BC.

4) Disconnect BC connector from CB K4 

(red) connector, then remove BC from the 
icemaker. 

5) Remove the actuator paddle from the 

switch mount. See Fig. 1.

6) Wipe down BC with a mixture of 1 part 

Hoshizaki "Scale Away" and 25 parts warm 
water. Rinse the parts thoroughly with 
clean water.

7) Reassemble BC and replace it in its correct 

position.
Note: If the magnet was removed for 

cleaning, be sure to replace it in its 
correct position. 

8) Reconnect BC connector to CB K4 (red) 

connector.

9) Move the control switch to the "ICE" 

position.

10) Replace the control box cover, right side, 

top, and front panels in their correct 
positions.

11) Turn on the power supply to start the 

automatic icemaking process.

Bin Control Proximity 
Switch Closed
(calling for ice)

Bin Control 
Proximity Switch 
Open (bin full, 
icemaker off or 
shutting down)

Bin Control 

To Control Board 
K4 (red) Connector

Actuator Paddle

Proximity Switch

Actuator Paddle

Magnet

Switch Mount