Справочник Пользователя для Fisher & Paykel MO-24SS

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. 

It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National 

Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk 

of electric shock by providing an escape wire for the electric current.

 – Improper use of the grounding plug can result in a risk of electric shock.

The electrical requirements are a 120 volt 60 hz, AC only, 15 amp. or more pro-

tected electrical supply. It is recommended that a separate circuit serving only this 

appliance be provided. 

The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall 

receptacle that is properly installed and grounded. Should you only have a 2-prong 

outlet, have a qualified electrician install a correct wall receptacle.

A 3-prong adapter may be purchased and used temporarily if local codes allow. 

Follow package directions.

A short power-supply cord is provided to reduce risk of becoming entangled in or 

tripping over a longer cord.
Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension cord that 

has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on 

the  microwave  oven.  The  marked    rating  of  the  extension  cord  should  be  AC  115-                 

120 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it can be pulled 

on by children or tripped over accidentally.

Notes:

1. If you have any questions about the grounding or electrical instructions, consult 

a qualified electrician or service person.

2. Neither DCS by Fisher & paykel nor the dealer can accept any liability for damage to the oven or personal injury 

resulting from failure to observe the correct electrical connection procedures.

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven 

is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position 

and signal of receiving antenna.

C

4"

4"

6"

A

The floor should be level for proper operation of the

oven. Be sure to check the local building code as it may

require that the opening be enclosed with sides, ceiling

and rear partition. The proper functioning of the oven

does not require the enclosure.

The Trim Kit includes all the necessary parts (including 

simulated frames that match the MO-24SS microwave 

oven) and easy-to-follow instructions for installation as 

well as location of the power supply. 

The ease of assembly for these kits will allow installa-

tion into an existing wall opening in less than an hour  

(if power outlet is already properly located).

All it takes are four steps and a phillips screw driver.

Outlet should NOT be in the shaded area as indicated.
1.  If the dimension of DEpTh (C) is more than 21", the 

outlet location may be any area on the rear wall.

2. The floor of the opening should be constructed of

plywood strong enough   

 

 

to support the weight    

 

 

of the oven and floor  

load (about 100 pounds). 

Unpacking and Installation Instructions

Grounding Instructions