Справочник Пользователя для Liebherr 7080 904-00

7

-  Always ensure good ventilation. Do not cover ventilation
  openings or grille.
-  Do not place appliance in areas of direct sunlight or next 

to a stove, heater or similar object.

-  The energy consumption depends on the installation con-

ditions, e.g. the ambient temperature.

-  Keep the time the appliance is open to a minimum.
-  The lower the temperature setting, the higher the power
 consumption.
-  Store food logically.
-  Ensure that all food is well packed and covered for stor-

age. This will prevent frost from forming.

-  Remove food as needed in order that it does not warm too
 much.
-  First cool warm food to room temperature before storing it.
-  If there is a thick layer of frost in the appliance: defrost the
 appliance.
Accumulated dust increases the
energy consumption:
-  Once a year, dust the refrigerating
  unit together with the metal grille of 

the heat exchanger at the back of 
the appliance.

You are recommended to clean the appliance before switch-
ing it on for the fi rst time (see "Cleaning"). Switch the ap-
pliance on 4 hours before loading it with frozen food for the 
fi rst time. 
Off: Using a coin, turn the arrow on the temperature control 

1

 to a setting between "1" und "6".

– The green ON-LED 

2

 is lit.

– The red warning-LED  

3

 twinkle up.

– The red warning-LED  is unlit as soon as the freezer com-

partment is cold enough (see "Red warning-LED"). 

To switch the appliance off: Turn the arrow on the temper-
ature control 

1

 to "0". The visual control-LED are unlit.

Setting "1" = lowest cooling setting, warm
Setting "6" = highest cooling setting, cold
•

 

We recommend a medium setting.

 

•

 

If you are storing frozen food and wish to ensure that the 

low freezing temperature is maintained, we recommend 
setting the temperature control to between "4" and "6".

• For long-term storage of frozen food a temperature of at 

least -18°C is recommended. Remember that the tempera-
ture depends on the ambient temperature (location of ap-
pliance), the number of times the door is opened and how 
much frozen food is stored. The setting should be adjusted 
accordingly if necessary.

G 1221 

Power supply (a.c.) and voltage at the operating point must 
comply with the details on the type plate which is located on the 
left-hand inside wall, next to the top freezer drawer. The socket 
must be fused with a 10 A fuse or higher. The socket should be 
easily accessible and not directly behind the appliance.
• Connect the appliance through a properly earthed plug 

NOTICE
Risk of damage to the electronic control system!
W

  Do not use stand-alone inverters (conversion of d.c. to a.c./ 

 

three-phase) or energy saving plugs.

WARNING
Fire and overheating hazard!
W

  Do not use extension cables or multiple socket outlets.

•  The fl oor on which the appliance stands should be horizon-

tal and level. To compensate for any unevenness, adjust the 
height of the feet with an open-ended wrench. 

•  Always position the appliance directly up against the wall.
•  The ventilation grilles should not be obstructed.
• Condensation may form on the outside of the refrigerator/

freezer during periods of high humidity. Constant ventilation of 
the installation site is recommend.

•  Do not place heat-emitting appliances, e.g. microwave oven, 

toaster, etc., on top of the freezer. 

• Keep burning candles, lamps and other items with naked 

fl ames away from the appliance so that they do not set the 
appliance on fi re.

•  Standard EN 378 specifi es that the room in which you install 

your appliance must have a volume of 1 m

3

 per 8 g of R 600a 

refrigerant used in the appliance, so as to avoid the formation of 
infl ammable gas/air mixtures in the room where the appliance is 
located in the event of a leak in the refrigerant circuit. 

   The quantity of refrigerant used in your appliance is indicated 
   on the type plate on the inside of the appliance.
• Fire hazard due to dampness!
   If live parts or the mains lead become damp this may cause 

short circuits.

-  The appliance is designed for use in enclosed areas. Do not 

operate the appliance outdoors or in areas where it is exposed 
to splash water or damp conditions.

• CAUTION! Risk of injury and danger of damage as a result of 

incorrect transport!

- Transport the appliance in a packed condition.
- Transport the appliance upright.
- Do not transport the appliance without assistance.
•  The appliance may be moved only when it is empty.
WARNING
Risk of fi re due to short circuit!
If the mains cable/connector of the appliance or of another
appliance touch the rear of the appliance, the mains cable/
connector may be damaged by the appliance vibrations,
leading to a short circuit.
•  Stand the appliance so that it is not touched by connectors
  or main cables.
•  Do not plug the appliance or any others into sockets located
  near the rear of the appliance.

The red warning-LED 

3

 lits up if the temperature in the 

freezer compartment is not cold enough, i.e. when the tem-
perature is above -8°C.
If the red warning-LED comes on during normal operation, 
check:
– whether there has been a lengthy interruption to the power 

supply; check the quality of the frozen food and prepare for 
consumption if necessary,

– whether the door is properly shut,
– whether fresh food has recently been inserted. 

If none of the above apply, consult your nearest customer 
service department as soon as possible, giving details of the 
type of appliance, index and service number.

 

A: 850 

mm

B: 553 

mm

C: 610 

mm

C1: 623 

mm