Справочник Пользователя для Festool PM561287

 

16 

Kapex KS120 Miter Saw 

The optional bed extensions provide a 

useful platform for using additional 

workpiece control accessories as well as 
extending the size of the bed of the Kapex 

saw. The optional bed extension accessory 

includes the crown stop, as shown to the 

upper right.  

The extension can be mounted to the left 

side or right side of the saw’s bed, or if two 

are used, to both sides simultaneously. 

The T-channel can also be used to secure 

additional clamping elements such as the 

Festool Quick Clamp or Screw Clamp shown
to the right. These clamps can be used for 

clamping larger workpieces, or used in 

conjunction with the Kapex hold down 

clamp for multiple clamping needs, such as 
the dado example shown on page 19. 

 

To install the bed extension, place the edge into the V-
channel of the Kapex bed, position the extension forward or 

back as needed, and then tighten the clamping knob (see 

image to the right). 

The crown stop is used for cutting crown moulding and 

holds the moulding at the desired angle against the fence of 
the saw so that it can be cut using a standard miter cut 

(refer to the 

 discussion on page 22).  The 

stop slides forward or back depending on the size of the 

moulding, and clamps in place to serve as a secondary 
fence.  

To set up the crown stop, place the moulding against the 

fence and bed of the saw, as shown in the lower left image, 
slide the crown stop up against the moulding, and tighten 

the clamping knob. Use the hold down clamp to secure the 

moulding while cutting, as shown in the lower right image.