Справочник Пользователя для Festool PM561287

 

8 

Kapex KS120 Miter Saw 

Congratulations on your purchase of a new Kapex Sliding 
Dual Compound Miter Saw. Before using your new miter 

saw, make sure you fully read and understand all of the 

instructions, precautions, and safety information presented 
in this manual.  

 

WARNING! To avoid tipping the miter saw during 

use, the miter saw must be placed on a stable 

surface. 

 

Note:  There is a 2.5 mm hex key needed for 

making adjustments located in the Styrofoam 

packing material. Take care not to lose it. 

 

Note: You may want to save the original box and 

packing material in case you ever need to send in 

the saw for service. 

The KS120 miter saw is ready to use right out of the box, 

but there are several placement options available, 

depending on the intended use. These options include: 

► 

For truly portable use, the KS120 may be used directly 
on a jobsite floor. The height of the cutting bed was 

specifically designed to coincide with the height of a 

Festool #1 Systainer, which can be used as an outfeed 
support. 

 

► 

The KS120 can also be used on a level and stable jobsite 

work table. The saw must be securely clamped to the 
table to help prevent it from tipping or falling off. 

 

► 

For a more permanent installation, the Kapex saw is 
equipped with 4 bolt holes, to be used with ¼-20 (M6) 

bolts to securely bolt the saw to a work table. 

 

► 

The Kapex saw was specifically designed to be 
compatible for operation on a Festool Multi-Function 

Table (MFT). The four feet under the saw coincide with 

the hole spacing of an MFT tabletop to keep the saw 

firmly in position, and the optional bolt kit permits quick 
mounting. 

 

 

 

Note: When clamping or bolting the Kapex to a 
work table, take care not to over tighten the 

clamps or bolts, as this may distort the saw base.