Справочник Пользователя для Kodak 9090DC

A-61662   October 2011

4-5

The Feeder Table adjustment buttons allow you to raise and lower the 
feeder table to accommodate different batch sizes. The feeder table 
must be empty to move to a new batch size position.

Down/Set 

• Down: lowers the feeder table. 

• Set: load a standard batch of documents, lower the skimmer and wait 

until the table is raised. Press and hold the Down/Set button for 2 
seconds.

Up — raises the feeder table. If the feeder table has documents in it, 
the Up button performs no function.

Two custom functions (F1 and F2) can be assigned via the Ngenuity 
Operator Utility. Available functions are: Feed Test Batch, Page Eject 
and Clean Print Head. 

By default, F1 is assigned to Feed Test Batch and F2 is assigned to 
Page Eject. See the section entitled, “Ngenuity Operator Utility” later in 
the chapter for more information. 

The Scan Monitor indicates that an error has occurred during scanning. 
The Scan Monitor indicators are lit in yellow.

Error — indicates that an error exists that is not covered by one of the 
other indicators. When an error is indicated, refer to the scanning 
application for more information.

Cover — indicates that the scanner cover is open. Carefully close the 
scanner cover. 

If this error occurs during scanning, press Clear/Restart after you have 
securely closed the cover.

Paper Jam — indicates a document jam within the scanner. Open the 
scanner cover, remove any jammed documents and close the cover. 
Press Clear/Restart to continue scanning.

Misfeed — indicates that a skimmer timeout or feeder jam has 
occurred.

• Skimmer timeout: the skimmer is active, but the document to be 

scanned did not move out of the feeder table (commonly due to roller 
slippage). 

• Feeder jam: the document to be scanned is fed but does not reach 

the scanner transport within the expected transit time.