Справочник Пользователя для Kodak 9090DC
A-61662 October 2011
4-19
Maintenance button
When you click the Maintenance button on the Ngenuity Operator
Utility main screen, the Maintenance screen will be displayed.
Utility main screen, the Maintenance screen will be displayed.
This screen provides scanner statistics for total hours, total pages fed
and total pages scanned, and also allows you to configure reminders
for required maintenance tasks to ensure optimal performance.
and total pages scanned, and also allows you to configure reminders
for required maintenance tasks to ensure optimal performance.
Scanner Statistics — provides statistics for Total On Time (awake
and sleeping), Total Pages (fed) and total Scanned Pages. These
totals are updated every 2 seconds.
and sleeping), Total Pages (fed) and total Scanned Pages. These
totals are updated every 2 seconds.
Configuration Maintenance Reminders — allows you to set the
interval values for triggering the reminders that are visible in the
Maintenance section of the Home screen.
interval values for triggering the reminders that are visible in the
Maintenance section of the Home screen.
Intervals can be set for cleaning the feed rollers (pick, drive and
separation rollers), the transport rollers, the optics and to replace the
feed rollers (pick, drive and separation rollers). These reminders can
also be individually enabled and disabled.
separation rollers), the transport rollers, the optics and to replace the
feed rollers (pick, drive and separation rollers). These reminders can
also be individually enabled and disabled.
To enable and adjust a maintenance reminder, click the check box next
to the corresponding component and use the up/down arrows in the
Page Interval column to change the value. Click Save to save your
changes or Restore to reset the values to the previously saved settings
The available interval settings and their defaults are:
to the corresponding component and use the up/down arrows in the
Page Interval column to change the value. Click Save to save your
changes or Restore to reset the values to the previously saved settings
The available interval settings and their defaults are:
Maintenance Operations — provides access to additional
maintenance and troubleshooting operations.
maintenance and troubleshooting operations.
Test Patch Reader — launches the patch reader test wizard, which
allows you to feed patch code sheets and determine if the patch
patterns are being accurately recognized by the scanner.
allows you to feed patch code sheets and determine if the patch
patterns are being accurately recognized by the scanner.
Reminder
Range
Default
Clean Feed Rollers (pick, drive and separation rollers)
1K - 50K
10K
Clean Transport Rollers
5K - 100K
50K
Clean Optics (camera covers, imaging guides, sensors)
5K - 150K
50K
Replace Feed Rollers (pick, drive and separation rollers)
100K - 900K
600K