Справочник Пользователя для Kodak 9090DC

6-4

A-61662  October 2011 

Feed rollers include the pick roller, drive roller and separation roller.

All feed rollers should be cleaned and/or replaced at the same time to 
ensure optimal scanner function. Maintenance reminder intervals (both 
cleaning and replacing) are based on all feed rollers having the same 
life cycle.

When the feed rollers become dirty, they may begin to slip on paper or 
cause multifeeds. To prevent feeding problems and avoid rubber tire 
replacements, it is recommended that you clean the tires on the rollers 
every 10,000 pages or as needed. Different document types, the 
condition of the documents being scanned, and the volume of scanning 
may require more frequent cleanings.

Always remove the rollers from the scanner before cleaning to ensure 
best results. 

1. Turn off the scanner and unplug it from the wall outlet.

2. Open the scanner cover.

3. Remove the pick roller by rotating the release lever up, push the 

pick roller to the right and remove it.

NOTE: Before cleaning the pick and drive rollers, inspect the tires. 

If the tires show signs of wear or damage, replace them. 
See “Replacement procedures” later in this chapter.

4. Using a roller cleaning pad, scrub the roller tires using a side-to-side 

motion. Rotate the roller to clean the entire surface.