Справочник Пользователя для Kodak 9090DC

A-61662   October 2011

B-9

If cleaning the print head using the F1 key does not provide the desired 
results, you can further clean the printer by following the steps below.

1. Turn off the scanner.

2. Remove the front (or back) imprinter unit from the scanner. See the 

sections entitled, “Removing the front imprinter” or “Removing the 
back imprinter” earlier in this chapter for instructions.

3. Remove the ink cartridge by grasping the ink cartridge holder and 

pulling the tab on the ink cartridge out from the ink cartridge holder.

4. Dampen a clean, lint-free cloth with water.

5. Hold the cloth in contact with the nozzles on the ink cartridge for a 

few seconds, then gently wipe the nozzle plate. Do not wipe the 
electrical contact area.

6. If ink remains on the nozzle plate, wipe again with a dry, lint-free 

cloth.

The back page imprinter assembly contains a spit pad that is used to 
absorb any excess ink from the front page imprinter during printing. The 
spit pad is located underneath the back page assembly’s entry tray. 

Over time the spit pad will become saturated and will need to be 
replaced. The life expectancy of the spit pad is expected to last as long 
or longer than the transport rollers. Contact Technical Support for spit 
pad replacement.