Справочник Пользователя для Lucent Technologies Release 8.2
Networking Screens
269
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
A
Screens Reference
Data Module - type
X.25 (used for BX.25 connections with the
r model)
This form applies only to the r model.
Common Fields
See
for descriptions of fields on this screen that
are not listed below.
Baud Rate
Specifies the data transmission rate for this connection.
Endpoint Type
Must be assigned as adjunct. An endpoint type is a type of packet switched data
endpoint that uses X.25 call control procedures. The X.25 Endpoint connects to
external ports on the PGATE board and to the TDM bus via a DS1 trunk. Ports
connected to the adjunct endpoint can be either DTEs or DCEs.
endpoint that uses X.25 call control procedures. The X.25 Endpoint connects to
external ports on the PGATE board and to the TDM bus via a DS1 trunk. Ports
connected to the adjunct endpoint can be either DTEs or DCEs.
Page 1 of 2
DATA MODULE
DATA MODULE
Data Extension: ____ Name: ____________________
Type: x.25 Remote Loop-Around Test? n
Port: __ COR: 1 Destination Number: ______
Baud Rate: __________ TN: 1 Establish Connection? n
Endpoint Type:_________ Connected Data Module: ____
Link: 1_ DTE/DCE: ___ Error Logging? _
Type: x.25 Remote Loop-Around Test? n
Port: __ COR: 1 Destination Number: ______
Baud Rate: __________ TN: 1 Establish Connection? n
Endpoint Type:_________ Connected Data Module: ____
Link: 1_ DTE/DCE: ___ Error Logging? _
Enable Link? n
Permanent Virtual Circuit? _ Highest PVC Logical Channel: __
Switched Virtual Circuit? _
Valid entries
Usage
9600, 19200, switched
Set to
9600
for DCS connections to the si model, or to
an r model with an external 9600 baud data line.
Set to
switched
for r-to-r connections with
common-channel signaling on DS1 trunks.
Set to
9600
for connections to Intuity.
Set to either
9600
or
19200
for CMS, depending on
the physical connectivity.
Valid entries
Usage
adjunct
Set to
adjunct
for DCS, CMS, or Intuity AUDIX.