Справочник Пользователя для Lucent Technologies Release 8.2
Japan TTC Q931-a Private Networking Protocols
B
Private Networking
Administration for Network Connectivity
CID: 77730
555-233-504 — Issue 1 — April 2000
402
Setting Up TTC Q931-a
Complete the following steps to set up TTC connections.
Begin
Steps
1
Verify that you have the appropriate DEFINITY circuit pack for integration
2
Enter “change system-parameters customer-options” on the command line of
your system administration screen.
your system administration screen.
3
On page 1, verify that the G3 Version field is V8 or later
4
On page 2, verify that ISDN-PRI field is y.
5
Administer the TTC DS-1 circuit pack.
Check for the following field entries:
~
Connect field — pbx
~
Interface — peer-master or peer-slave
~
Peer Protocol — TTC
~
D-channel: (This item must match between the local and receiving switches)
~
Channel Numbering — sequential or timeslot (This item must match between
the local and receiving switches)
the local and receiving switches)
6
Administer or check the TTC ISDN trunk group(s) associated with the DS1
circuit pack.
circuit pack.
Check for the following field entries on page 1 of the Trunk Group screen:
~
Group type: isdn
~
Supplementary Service protocol — a
~
Outgoing Display? y
Check for the following field entries On page 2
~
Disconnect Supervision — y
~
Numbering format — public, private, unknown, unk-pvt
~
Send Called/Busy/Connected Number — y
~
Sending Calling Number — y
~
Send Name — n
End