Справочник Пользователя для Lucent Technologies Release 8.2

Скачать
Страница из 524
H.323 Trunk Administration 
45
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
2  
H.323 Trunks
Task 5 — Create a trunk group  
This task creates a new trunk group for H.323 trunks. Each H.323 trunk must be a 
member of an ISDN trunk group and must be associated with an H.323 signaling 
group.
Note:
The following steps address only those fields that are specifically related 
to H.323 trunks. The other fields are administered as for previous releases 
and are described in the Administrator’s Guide.
Begin
Task 5 Steps
> Open new Trunk Group form — enter  
a tr n
> Enter values
add trunk-group n
 Page   1 of  10 
                                TRUNK GROUP                                     
Group Number: 3                    Group Type: isdn          CDR Reports: y
  Group Name: TG 3 for H.323 trunks       COR: 1        TN: 1        TAC: 103 
   Direction: two-way        Outgoing Display? n         Carrier Medium: IP     
 Dial Access? n                Busy Threshold: 99          Night Service: 
Queue Length: 0  
Service Type: tie                   Auth Code? n            TestCall ITC: rest
                         Far End Test Line No: 
TestCall BCC: 0
TRUNK PARAMETERS
         Codeset to Send Display: 0     Codeset to Send National IEs: 6
        Max Message Size to Send: 260   Charge Advice: none             
  Supplementary Service Protocol: a     Digit Handling (in/out): enbloc/enbloc  
            Trunk Hunt: cyclical              QSIG Value-Added Lucent? n
                                                   Digital Loss Group: 13
Calling Number - Delete:     Insert:                 Numbering Format: 
              Bit Rate: 1200         Synchronization: async    Duplex: full
 Disconnect Supervision - In? y  Out? n
 Answer Supervision Timeout: 0 
Field
Conditions/Comments
Group Type
Enter 
isdn
.
Carrier Medium
Enter 
ip
Service Type
Enter 
tie
TestCall ITC:
Enter 
unre
 (unrestricted).
TestCall BCC:
Enter 
0
Codeset to Send Display
Enter 
0
Note:
Outgoing Display
This field may need to be changed if the 
far-end is a non-DEFINITY switch.