Справочник Пользователя для Barco SJ/T 11363-2006

Setup Menu

When the Auto Acquire mode is 

, the PDS automatically detects and 

acquires the input video type and resolution (in most cases), and limits menu 
selections to those applicable to the detected video type. 

If you are an advanced user and you know the exact timing parameters for your 
input(s), you can turn the Auto Acquire mode 

, and dial in your timing 

parameters manually.  

The Auto Input Cfg function enables or disables the automatic input configuration mode.  
Values are:  

 and 

 (default).  

When 

, the system automatically finds the first and last pixel on each edge of 

the selected input, and ensures (to the best possible extent) that the entire image 
is visible.  In addition, the system automatically phases the input to determine the 
correct sampling phase.  

These functions will only be performed under the following conditions:

When an input without a saved configuration file is selected.

When the input signal changes sync rates. 

When an input with a saved configuration file is selected, but the input 
timing is different from the saved configuration.

When 

, the system uses the last known configuration for each input, to the 

greatest extent possible.    

When the Auto Input Save mode is enabled, the system automatically saves the selected 
input after it has been acquired for the first time.  If the Auto Acquire mode is 

, the field 

has no effect.  The default is 

.

From the User Preference Menu, select Background to change the system’s background 
color between “Black” and “Gray.”  This is a global setting. 

When set to Gray, you can clearly see the edges of an input, particularly when the input’s 
aspect ratio does not match the output’s aspect ratio.  Note that the background selection 
persists between source changes.

If you have already saved configuration files for your inputs, it 
is recommended that you turn the Auto Acquire mode 

.  This provides the fastest transition times.  When 

the mode is 

, transition times will be greater, due to 

the time required to analyze the input timing for each source.

This is the “automatic” version of the manual Auto Input Cfg 
mode, which is located in the Input Sizing Menu.  Refer to 
the “

” section on page 43 for details.