Справочник Пользователя для Asante Technologies 35516

 

14 

1000BaseT requires that all four pairs (8 wires) be connected correctly, using Category 5 or better 
Unshielded Twisted Pair (UTP) cable (to a distance of 100 meters). Table 2-2 shows the correct pairing of all 
eight wires. 
 

1

 

2 White/Orange

 

2

 

2 Orange/White

 

3

 

3 White/ Green

 

4

 

1 Blue/White

 

5

 

1 White/Blue

 

6

 

3 Green/White

 

7

 

4 White/Brown

 

8

 

4 Brown/White

 

 
Cabling requirements for the optional hardware modules depend on the type of module installed. Use the 
following guidelines to determine the particular cabling requirements of the module(s): 
 

• 

1000BaseSX GBIC: Cables with SC-type fiber connectors; 62.5-micron multi-mode fiber (MMF) 
media up to 275 meters (902 feet) long, or 50-micron MMF media up to 550 meters (1805 feet) 
long 

• 

1000BaseLX GBIC: Cables with SC-type fiber connectors; 10-micron single-mode fiber media up to 
5 kilometers (16,405 feet) long 

• 

1000BaseLH GBIC: Cables with SC-type fiber connectors; 10-micron single-mode fiber media up to 
20 kilometers (65,617 feet) long 

• 

1000BaseLX Long Haul GBIC: Cables with SC-type fiber connectors; 10-micron single-mode fiber 
media up to 100 kilometers (328,100 feet) long 

• 

1000BaseLZ GBIC: Cables with SC-type fiber connectors; 10-micron single-mode fiber media up to 
120 kilometers (393,701 feet) long 

• 

1000BaseT: Category 5 or better Unshielded Twisted Pair (UTP) cable to a distance of 100 meters 
(328.1 feet) long 

 
When attaching a workstation to the switch, a standard straight-through CAT5 cable may be used, even 
when the workstation is attached via a patch panel. No crossover cable is needed with the MDX/MDI ports. 
It is recommended that the switch be kept off the network until proper IP settings have been set. 
 

 
In order to configure the switch, connect to it through a console (out-of-band management), running a 
terminal emulation program, such as HyperTerminal. 
 

 
To connect the switch to a console or computer, set up the system in the following manner: 
 

1.  Plug power cord into the back of switch. 
2.  Attach a straight-through serial cable between the RS232 console port and a COM port on the PC. 
3.  Set up a HyperTerminal (or equivalent terminal program) in the following manner: 
 
•  Open the HyperTerminal program, and from its file menu, right-click on Properties 

•  Under the Connect To tab, choose the appropriate COM port (such as COM1 or COM2)