Справочник Пользователя для Mitsubishi Electronics HC3000

Скачать
Страница из 40
EN-6
Preparing your projector
Cables
Power supply parts
RGB cable for PC
(246C521-10) 
Mini D-SUB
15-pin
Mini D-SUB
15-pin
D-SUB 9-pin
8-pin
Filter parts
RS-232C cable 
(246C508-10)
•  Used for projector control 
by computer.
Power cord 
(two)
(246C483-10, 246C383-20)
Remote control parts
Remote control
(290P133-20)
R03 (Size-AAA) 
battery (two) 
Filter cover (Filter)
(
761B421-30
)
Cap
(
761C765-10
)
Others
• Lens cap (Attached to the 
projector)
• User manual (English only)   
(871D420-80)
• CD-ROM (with User manual)   
(919C137-60)
• Safety manual (871D421-60)
• Quick Start up (857D078-10)
1
2
3
Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in 
the package. 
Important:
•  The attached power cords are to be used exclusively for this product. Never use them for other products.
Inserting the batteries into the remote control
1.  Remove the back lid of the remote control.
2.  Check the polarity (+), (-) of the batteries, and set them 
correctly, inserting their (-) side fi rst.
•  If the battery is inserted from the (+) side fi rst, inserting 
the (-) side is diffi cult because the coil spring end hits 
on the battery side. If the battery is forced in this way, 
the outer label of the battery may get ripped and it may 
cause a short-circuit and heating.
3.  Attach the back lid.
Important:
•  Use two size-AAA batteries (R03).
•  Replace the two batteries with new ones when the remote 
control is slow to respond.
CAUTION: 
•  Use of a battery of wrong type may cause explosion.  
•  Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used. 
•  Dispose of used batteries according to your local regulations. 
•  Batteries may explode if misused. Do not recharge, disassemble, or throw them in fi re.
•  Be sure to handle the batteries according to the instructions.  
•  Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control. 
•  Keep batteries out of reach of children and pets. 
•  Remove the batteries, if the remote control is not used for a long time. 
•  Do not combine a new battery with an old one.
•  If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in 
contact with your eyes, rinse them with water and then consult your doctor.