Справочник Пользователя для Mitsubishi Electronics XL21

 
 

 

REV 2.4 

 

37 

 

Set the system memory as shown below to suit a configuration. The parameters are effective for 
all input memories and display memories. 
Press and hold [MENU2] button to display the system memory menus. You can exit the menu by 
[ESC] button. 

Used to set brightness mode. The initial setting is NORMAL. 
BRIGHT mode can make cubes brighter. The lamp life becomes shorter than NORMAL mode. 

[Procedure] 

1.  Select LAMP POWER in MISC FUNCTION in the system menu. 
2.  Set NORMAL or BRIGHT. 

X

X

L

L

2

2

1

1

This adjustment is normally unnecessary. 
Used to set lamp-driving system. The initial setting is F-REDUCTION. 
• 

F-REDUCTION: It drives with lamp flicker reduction. 

• 

LONG LIFE: It drives with longer lamp life than F-REDUCTION mode even though the flickers 
may occur. 

• 

NORMAL: it automatically change F-REDUCTION and LONG LIFE mode. 

[Procedure] 

1.  Select LAMP MODE in MISC FUNCTION in the system menu. 
2.  Set F-REDUCTION, LONG LIFE or NORMAL. 

This adjustment is normally unnecessary. 
Used to select the termination of analog synchronizing signal in the main input. The initial setting 
is 1K (1KΩ  termination). If the synchronization is lost while 5-line (separate sync) analog input in 
the main input, set this item to 75 (75Ω  termination). The image may be displayed correctly. 
[Procedure] 
1.  Select TERMINATE in MISC FUNCTION in the system menu. 
2.  Set 75 or 1K. 

This adjustment is normally unnecessary. 
Used to select the termination of analog synchronizing signal in the input board. The initial setting 
is 1K (1KΩ  termination). If the synchronization is lost while 5-line (separate sync) analog input in 
the input board, set this item to 75 (75Ω  termination). The image may be displayed correctly. 
[Procedure] 
1.  Select S.TERMINATE in MISC FUNCTION in the system menu. 
2.  Set 75 or 1K.