Справочник Пользователя для Mitsubishi Electronics XL21

 

 

50 

 

This adjustment is normally unnecessary. 
Used to turn on/off the three-dimensional Y/C separation circuit. The initial setting is ON. On 
setting can display an NTSC signal with less dot interference image in COMPOSITE input. 
[Procedure] 
1.  Select 3D Y/C in MISC FUNCTION in the system menu. 
2.  Set ON or OFF. 

This adjustment is normally unnecessary. 
Used to boost the brightness in white areas of a displaying image utilizing a white segment and 
blanking areas in the color wheel. The initial setting is ON. When SENSOR is set RUN, WHITE 
BOOST should be set OFF. 
When you set other than OFF, follow the procedure below. 
[Procedure] 
1.  Adjust the color balance (chapter 1.5.2, on page 44) in a state of WHITE BOOST OFF at 

first. 

2.  After the adjustment, display the adjustment white by pressing [TEST] button three times. 
3.  Select WHITE BOOST in MISC FUNCTION in the system menu. 
4.  Adjust the white boost values as highly as possible so as to align the brightness of the 

screens. 

Note: 
• 

If there is something wrong with the total picture quality on actual contents, set the white 
boost OFF on all cubes. Also, when you cannot identify the final contents to be displayed, 
set it OFF. 

• 

This boost function is not effective for a display wall that still has a wide variation of 
brightness and tint before CSC adjustment. It can be used only in a small display wall 
system.