Справочник Пользователя для Zebra Technologies 105SL Plus
147
Troubleshooting
Miscellaneous Issues
7/3/13
P1056468-002
Miscellaneous Issues
identifies miscellaneous issues with the printer, the possible causes, and the
recommended solutions.
Table 19 • Miscellaneous Printer Problems
Problem
Possible Cause
Recommended Solution
The control panel
display shows a
language that I
cannot read
display shows a
language that I
cannot read
The language parameter was
changed through the control
panel or a firmware command.
changed through the control
panel or a firmware command.
1.
On the control panel display, press SETUP.
2.
Press the LEFT ARROW once to move to
the LANGUAGE parameter.
the LANGUAGE parameter.
3.
Use PLUS (+) or MINUS (-) to scroll
through the language selections. The
selections for this parameter are displayed in
the actual languages to make it easier for you
to find one that you are able to read.
through the language selections. The
selections for this parameter are displayed in
the actual languages to make it easier for you
to find one that you are able to read.
4.
Select the language that you want to display.
The display is missing
characters or parts of
characters
characters or parts of
characters
The display may need
replacing.
replacing.
Call a service technician.
Changes in
parameter settings
did not take effect
parameter settings
did not take effect
Some parameters are set
incorrectly.
incorrectly.
1.
Check the parameters and change or reset if
necessary.
necessary.
2.
Turn the printer off (O) and then on (I).
A firmware command (such as
device.command_override
device.command_override
)
turned off the ability to change
the parameter.
the parameter.
Refer to the Programming Guide for ZPL, ZBI,
Set-Get-Do, Mirror, and WML or call a service
technician.
Set-Get-Do, Mirror, and WML or call a service
technician.
A firmware command changed
the parameter back to the
previous setting.
the parameter back to the
previous setting.
If the problem persists, there
may be a problem with the
main logic board.
may be a problem with the
main logic board.
Call a service technician.
Non-continuous
labels are being
treated as continuous
labels.
labels are being
treated as continuous
labels.
The printer was not calibrated
for the media being used.
for the media being used.
.
The printer is configured for
continuous media.
continuous media.
Set the printer for the correct media type
(gap/notch, continuous, or mark). See
(gap/notch, continuous, or mark). See
All indicator lights
are on, nothing is on
the display (if the
printer has a display),
and the printer
locks up.
are on, nothing is on
the display (if the
printer has a display),
and the printer
locks up.
Internal electronic or firmware
failure.
failure.
Call a service technician.
The printer locks up
while running the
Power-On Self Test.
while running the
Power-On Self Test.
Main logic board failure.
Call a service technician.