Справочник Пользователя для Zebra Technologies ZD500

Maintenance
RTC Battery

P1062653-002 Rev. A

ZD500 Series™ Thermal Transfer Printer User’s Guide

1/16/2014

Align the platen with the gear to the left and lower it into the printer’s bottom frame.

Rotate the platen bearing latch release tabs down on the right and left sides towards the 
rear of the printer and snap them into place.

Allow the printer to dry for one minute before closing the dispenser door, media cover or 
loading labels.

There are no user level maintenance procedures beyond those detailed in this section. See the 

 for more information on diagnosing printer and print problems.

The RTC (Real-Time Clock) battery is not operator replaceable. See a Zebra authorized 
service technician to replace the battery.

There are no replaceable fuses in the ZD500 Series™ printer or power supply.

Caution • The printer has a three volt lithium battery. You can discern a low or flat battery if 
the printer provides a consistently delayed date stamp. Battery replacement must be performed 
by a qualified service technician. Only use a Zebra approved replacement battery.

Important • Recycle batteries according to local your guidelines and regulations. Wrap the 
battery when disposing (or storing) to avoid a short circuit.

DO NOT short circuit the battery. Short circuiting the battery may result in heat 
generation, fire or bursting.

DO NOT heat, disassemble or dispose of battery in fire.