Справочник Пользователя для Zebra Technologies ZD500
Setup
Select a Location for the Printer
Select a Location for the Printer
16
P1062653-002 Rev. A
ZD500 Series™ Thermal Transfer Printer User’s Guide
1/16/2014
Select a Location for the Printer
The printer and media need a clean safe area with moderate temperatures to have optimal print
operations.
operations.
Select a location for the printer that meets these conditions:
• Surface: The surface where the printer will be located must be solid, level, and of
sufficient size and strength to hold the printer.
• Space: The area where the printer will be located must include enough space for
ventilation, opening the printer (media access and cleaning), and for accessing the printer
components and connectors. To allow for proper ventilation and cooling, leave open space
on all sides of the printer.
components and connectors. To allow for proper ventilation and cooling, leave open space
on all sides of the printer.
• Power: The printer should be within a short distance of an appropriate power outlet that is
easily accessible.
• Data communication interfaces: The printer must be within range of your WLAN or
Bluetooth radio (if applicable) or within an acceptable range for other connectors to reach
your data source (usually a computer).
your data source (usually a computer).
Data cables should not be routed with or near power cords or conduits, fluorescent
lighting, transformers, microwave ovens, motors or other electrical noise and interference
sources. These interference sources may interfere with communications, host system
operation, and printer functionality.
lighting, transformers, microwave ovens, motors or other electrical noise and interference
sources. These interference sources may interfere with communications, host system
operation, and printer functionality.
• Operating conditions: Your printer is designed to function in a wide range of
shows the temperature and relative humidity requirements for the printer when it is
operating.
operating.
Caution •
Do not place any padding or cushioning material under or around the base
of the printer because this restricts air flow and could cause the printer to overheat.
Table 3 • Operating Temperature and Humidity
Mode
Temperature
Relative Humidity
Thermal Transfer
41° to 104°F (5° to 40°C)
20 to 85% non-condensing
Direct Thermal
32° to 104°F (0° to 40°C)
Table 4 • Non-Operating and Storage Temperature and Humidity
Mode
Temperature
Relative Humidity
Both
-40° to 140°F (-40° to 60°C)
5 to 85% non-condensing