Справочник Пользователя для Zebra Technologies ZD500

Скачать
Страница из 160
iii
1/16/2014
ZD500 Series™ TThermal Transfer Printer User’s Guide
P1062653-002Rev. A
Compliance and Regulatory Statements
FCC Compliance Statement (USA)
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause 
undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital 
Devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference when the equipment is operated in a residential 
environment. This equipment generates, uses, and can radiate radio frequency energy and, if 
not installed and used in accordance with the product manuals, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television 
reception, the user is encouraged to do one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected.
• Consult the dealer or an experienced RF service technician for help. 
Important • 
1.
The radio must be installed with a minimum 20 cm separation between the user and the 
antenna.
2.
The radio must not be co-located or used in simultaneous transmitting condition with 
another radio.
3.
The host system shall have a label to indicate that the system contains a certified module.
An example is “Contains FCC ID : I28MD-EXLAN11N  , IC ID: 3798B-EXLAN11N”.
4.
The radio is for indoor use only in the 5150-5250 GHz frequency range.
The user is cautioned that any changes or modifications not expressly approved by Zebra 
Technologies could void the user’s authority to operate the equipment. To ensure compliance, 
this printer must be used with fully shielded communication cables.
Mexico — NOM-121-SCT1-2009
Este equipo ha sido diseñado para operar con las antenas que enseguida se enlistan y para una 
ganancia máxima de antena de [x] dB. El uso con este equipo de antenas no incluidas en esta 
lista o que tengan una ganancia mayor que [x] dB quedan prohibidas. La impedancia requerida 
de la antena es de [y] ohms.
auden - p/n 220370-09
• Gain = 2.77dbi @ 2.4 GHz
• Gain = 2.69 - 3.19dBi @ 5 GHz
• Impedance = 50 ohms