Справочник Пользователя для Ricoh AP610N
Replacing the Maintenance Kit
33
2
Replacing the Friction Pad
Replace all friction pad of the tray.
There are two kinds of friction pads.
One is for the paper tray (Tray 1), and
the other are for the paper feed unit(s)
(Tray 2, 3). The following procedure
shows how to replacing friction pad
of the paper tray (Tray1).
There are two kinds of friction pads.
One is for the paper tray (Tray 1), and
the other are for the paper feed unit(s)
(Tray 2, 3). The following procedure
shows how to replacing friction pad
of the paper tray (Tray1).
A
Lift the paper tray slightly, and
then pull it out until it stops.
then pull it out until it stops.
B
Lift the front side of the tray, and
then pull it out of the printer.
then pull it out of the printer.
C
Remove paper from the paper
tray. Place the tray upside down
on a flat surface.
tray. Place the tray upside down
on a flat surface.
D
Use a sharp-pointed item like a
ball-point pen, to release the two
catches that lock the friction pad.
ball-point pen, to release the two
catches that lock the friction pad.
Note
❒ The friction pad may fall off
when the catches are released.
Place your hand over the fric-
tion pad while releasing the
catches.
Place your hand over the fric-
tion pad while releasing the
catches.
❒ The friction pad spring may
come off. Be careful not to lose
the friction pad spring.
the friction pad spring.
❒ The catches that lock the friction
pad are located at the very back.
AGN029S
ZKGY140E
ZKGM160E
ZKGM170E
KirP4GB_Mainte-F6_FM_forPaper.book Page 33 Thursday, May 12, 2005 11:48 AM