Справочник Пользователя для Citizen Systems CLP-8301

Chapter 4 Media (Paper) and Ribbon

----

Temporarily winding the ribbon with a length of about 300 mm (1 ft) unwound between bobbins

around the lower, bottom side of the printhead assembly, first fit both sockets of the destination and

source ribbon bobbins, then click into place both knobs of the destination and source ribbon bobbins.

Remove any slackness and wrinkling of ribbon by turning the knob of the destination ribbon bobbin

clockwise (and/or the knob of the source ribbon bobbin counterclockwise if necessary) and make

sure that the ribbon is wound evenly between bobbins being installed.

7 Lower the printhead assembly with ribbon fully to the end and push it to lock. The ribbon is now

loaded. Lastly close the top cover.

Socket of destination
ribbon bobbin

Knob of destination ribbon bobbin

Knob of source ribbon bobbin

Socket of source ribbon
bobbin