Справочник Пользователя для Citizen Systems CBM-230/231

CBM-230/231 User’s Manual

CITIZEN

32

8 DRAWER KICK CONNECTOR

 8.1 Specifications

  (1) Drawer kick drive signal
     The pulses specified by ESC p are output. The state of the switch(+) can be known through the pin 34
     of the interface connector when parallel interface is used, and through the ESC u command
     when the serial interface is used.

  (2) Electrical characteristics
      1) Drive voltage

: DC 24 V

      2) Drive current

: 0.8 A at maximum(should be within 510 ms)

      3) Switch signal

: Signal level  

"L" = 0 to 0.5 V

                                

"H" = 3 to 5 V

 8.2 Connector's Pin Configuration

       

No.

SIGNAL NAME

FUNCTION

1

FG

Frame ground

2

DRAWER 1

Drawer 1 driving signal

3

DRSW

Drawer SW input

4

VDR

Drawer driving power supply

5

DRAWER 2

Drawer 2 driving signal

6

GND

Common ground on the circuits

                           Connector used      

: TM5RJ3-66(HIROSE)

                           Applicable connector

:Equivalent to TM3P-66P(HIROSE)

      [Cautions] 1) No output is allowed during printing.
               2) The drawers 1 and 2 cannot be driven at the same time.
               3) A solenoid for the drawer should be of 36 Ohm or more.
        

(See to it that an output current will not exceed 0.8 A.

                 Be careful not to use a drawer with a current over 0.8A to avoid damage to the printer.)
  

 8.3 Drive Circuit