Справочник Пользователя для Kodak FC1

2 

Using the KODAK Negative Film Processing Cartridges FC1 and FC2 

• CIS-254

 

Catalog numbers are as follows: 

Product 

CAT Number 

KODAK Negative Film 
Processing Cartridge 
FC1 

2 801 

7519 

KODAK Negative Film 
Processing Cartridge 
FC2 

2 867 

2701 

KODAK Rinse Tablets* 

4 

191 3110 

KODAK Negative Film 
FC Tank Developer 

1 833 

9723 

KODAK Negative Film 
FC Tank Bleach 

1 107 

2024 

KODAK Negative Film 
FC Tank Fixer 

1 813 

4421 

KODAK Negative Film 
FC Tank Rinse 

3 872 

4791 

*Used in water reservoir on processor

 

Handle all chemicals carefully. When you mix solutions, 
wear goggles or a face shield, a protective rubber apron, 
and protective gloves made with neoprene or nitrile 
rubber. Clean protective clothing after use to remove any 
chemical residue that can cause contamination. For more 
information about potential health hazards and safe 
handling of specific Kodak chemicals, see the label and 
the Material Safety Data Sheet (MSDS) for the chemical. 
Consult the MSDS for regional contact information. 
MSDS copies are available at the Kodak website at 
www.kodak.com/go/photochemicals.  

CONVERTING TO THE KODAK 
NEGATIVE FILM PROCESSING 
CARTRIDGES 

No processor adjustments are required to use KODAK 
Negative Film Processing Cartridges FC1 and FC2. These 
cartridges are designed to mix and replenish on top of 
existing solution. Use the same processor settings that you 
use with your current chemical cartridge. Standard 
conditions are shown in Figure 1 on page 3. 

Use the following Kodak chemicals to prepare fresh 
working tank solutions: 

Developer Tank (N1) 
Use KODAK Negative Film FC Tank Developer  
CAT No. 833 9723. Each kit makes 5.2 litres. Two kits 
are required for the FP363SC processor. Three kits are 
required for the FP563SC processor

.

 Follow the directions 

in the following table: 
 

 

Processor 

1 

Mix 2 bottles of 
developer Part A 
with 2 litres of water 
in mixing bottle. Add 
solution to processor 
developer (N1) tank. 

Add 4 litres of water 
to processor 
developer (N1) tank.  
Then mix 3 bottles of 
developer Part A 
with 2 litres of water 
in mixing bottle. Add 
solution to processor 
developer (N1) tank. 

2 

Mix 2 bottles of 
developer Part B 
with 2 litres of water 
in mixing bottle. Add 
solution to processor 
developer (N1) tank. 

Mix 3 bottles of 
developer Part B 
with 2 litres of water 
in mixing bottle. Add 
processor developer 
(N1) tank. 

3 

Mix 2 bottles of 
developer Part C 
with 2 litres of water 
in mixing bottle. Add 
processor developer 
(N1) tank. 

Mix 3 bottles of 
developer Part C 
with 2 litres of water 
in mixing bottle. Add 
processor developer 
(N1) tank. 

4 

Position tank level 
gauge on processor 
developer (N1) rack. 
Add water to N1 
level mark (about 
2.3 litres). 

Position tank level 
gauge on processor 
developer (N1) rack. 
Add water to N1 
level mark (about 
2.4 litres).