Справочник Пользователя для Epson EB-826W

Status

Cause

Remedy or Status

: Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be

careful to avoid pieces of broken glass (you cannot continue projecting until the Lamp is replaced). s 

Check that the lamp cover and lamp are securely installed. s 

If the lamp cover or the lamp are not installed correctly, the lamp does not turn on.

When using at an altitude of 1500 m or more, set High Altitude Mode to On. s 

Auto Iris Error
Power Err. (Ballast)

Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s 

m

o

:   Lit  

:   Flashing  

:   Off  

:  Varies  according  to  the  projector  status

Status

Cause

Remedy or Status

High Temp Warning

(This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s 

Replace Lamp

Replace it with a new Lamp. s 

If you continue to use the Lamp after the replacement period has passed, the possibility that the lamp may explode increases.
Replace it with a new Lamp as soon as possible.

q

• If  the  projector  is  not  operating  properly,  even  though  the  indicators  are  all  showing  normal,  refer  to  "When  the  Indicators  Provide  No  Help"  

.

• If  the  error  is  not  indicated  in  this  table,  stop  using  the  projector,  disconnect  the  power  cable  from  the  electrical  outlet,  and  contact  your  local  dealer  or

the  nearest  address  provided  in  the  Support  and  Service  Guide.  s