Справочник Пользователя для Alcatel Carrier Internetworking Solutions 6000 OAW-LC-2G24F
OmniAccess 6000 LC-2G24F Installation Notes: Installation Guide
2
Part 031658-00
May 2005
This handle is used for removing or inserting the module into the switch
chassis.
chassis.
24 FE Ports
These ports are used to connect APs and wired LAN segments to the Alcatel
Wireless LAN Switch. These ports provide 10/100 Mbps Ethernet connectivity,
and in some cases, power and serial connectivity as well. See
Wireless LAN Switch. These ports provide 10/100 Mbps Ethernet connectivity,
and in some cases, power and serial connectivity as well. See
for more information.
LNK/ACT LED
Each FE port has its own LNK/ACT LED, located at the left side of the port.
During operation, these LEDs provide the following status information:
During operation, these LEDs provide the following status information:
Module Indicator LEDs
Power LED
This LED lights green when the line card is properly installed and the system is
powered up.
powered up.
Status LED
During operation, the Status LED provides the following information:
C
AUTION
—Do not use the line card handle to lift or move the Alcatel
Wireless LAN Switch. Serious damage could result.
T
ABLE
1 FE LNK/ACT LED
Status
Description
Off
No Ethernet link on the port.
Green
An Ethernet link has been established on the port, but no
data is currently being transmitted or received.
data is currently being transmitted or received.
Flashing
Green
Green
The port is transmitting or receiving data. The flashing
rate is proportional to your network activity.
rate is proportional to your network activity.
Amber
The Ethernet link on the port is encountering errors.
T
ABLE
2 Line Card Status LED
Status
Description
Off
The line card is powered off or initializing.
Green
The line card is operating properly.
Amber
The line card is being initialized.
Red
The line card has failed.
3
4
A
B