Справочник Пользователя для Netopia CLI 874
Motorola Netopia® Router CLI Commands 2-105
The default count is 5, and the default timeout is 0.
receive tftp config [ser ver-name file-name]
This command allows you to initiate a configuration file upload from the command line inter face. If the TFTP
ser ver name and config file name were set previously, either by a previous invocation of this command or via
the menu console, then you do not need to supply the ser ver and file name. If the upload is successful, the
router will automatically reboot. If the upload is unsuccessful, in menu mode you can go to:
ser ver name and config file name were set previously, either by a previous invocation of this command or via
the menu console, then you do not need to supply the ser ver and file name. If the upload is successful, the
router will automatically reboot. If the upload is unsuccessful, in menu mode you can go to:
for information about what went wrong.
receive tftp [ wan { 1 | 2 }] firmware [ser ver-name [file-name]]
This command allows you to receive a firmware file that is located remotely on a TFTP ser ver into the router by
means of a TFTP file transfer.
means of a TFTP file transfer.
The wan 1 and wan 2 options allow you to specify that the firmware upgrade is to be sent one of the WAN
inter face modules. As with the regular receive tftp firmware comand, ser ver-name and file-name are optional if
they are already specified. If ser ver-name or file-name are not already specified, it is necessar y to specify
them. (Specifying them with this command will set them.)
inter face modules. As with the regular receive tftp firmware comand, ser ver-name and file-name are optional if
they are already specified. If ser ver-name or file-name are not already specified, it is necessar y to specify
them. (Specifying them with this command will set them.)
send tftp config [ser ver-name file-name]
The configuration file will be stored on the TFTP ser ver as a binar y image. Note that the file must already exist
on the ser ver and be writable.
on the ser ver and be writable.
show tftp last error
An empty string indicates no error. Other possible return values are: File not found, Unauthorized, Disk Full,
Illegal Operation, Bad TID, File Already Exists, No Such User, and Unknown Error.
Illegal Operation, Bad TID, File Already Exists, No Such User, and Unknown Error.
show tftp status
The possible return values are: Idle, Reading Firmware, Reading Wanlet Firmware, Reading Config, Writing
Config, Idle, **TRANSFER FAILED**.
Config, Idle, **TRANSFER FAILED**.
receive xmodem [ wan { 1 | 2 }] firmware
This command allows you to receive a firmware file that is located locally into the router by means of an
XMODEM file transfer.
XMODEM file transfer.
The wan 1 and wan 2 options allow you to specify that the firmware upgrade is to be sent one of the WAN
inter face modules.
inter face modules.
The underlying routine that is invoked blocks until either the file has been successfully received or some
condition caused the transfer to abor t. Therefore when this command is invoked the following will appear:
condition caused the transfer to abor t. Therefore when this command is invoked the following will appear:
Main
Menu
Statistics &
Logs
Device Event
Histor y