Справочник Пользователя для Netopia CLI 874

telnet { hostname | ip-addr } [ port value ] [ source ip_addr ]
show telnet sessions

Note:

These commands are suppor ted beginning with Firmware Version 8.7.

These commands allow you to initiate or show up to six telnet sessions from the command line without 
returning to the console menu inter face. Using the command line, you can resume sessions star ted by the 
console menu and vice versa.

Example:

#show telnet sessions

#1 192.168.1.253

#2 192.168.1.91

#3 10.8.200.16

#4 no active session

#5 no active session

#6 no active session

telnet suspend [ a... z ]
show telnet suspend
telnet resume [ 1... 6 ]
telnet terminate [ 1... 6 ]

Note:

These commands are suppor ted beginning with Firmware Version 8.7.

These commands allow you to suspend telnet sessions indicated by alphabetic letter, a through z, from the 
command line.

Telnet sessions specified by number, 1 through 6, may be resumed or terminated.

The show command displays telnet sessions that have been previously suspended using the suspend 
command.

telnet server port [ por t number ]
show telnet server port

These commands allow you to set or display the TCP por t on which the router is currently listening for incoming 
telnet management sessions. If you change the por t number, the router will immediately stop accepting new 
sessions at the old por t number, and only accept incoming sessions on the new por t number.  All sessions 
currently connected to the old por t number will remain connected.  Allowed values for por t number are 1 - 
65535, except for 80 and 1723.

time hh:mm [ am | pm ]
show time

These commands allow you to set or display the current time for the router’s system clock.