Справочник Пользователя для Netopia CLI 874
2-14 Command Line Interface Commands Reference
heartbeat enable { yes | no }
show heartbeat enable
show heartbeat enable
These commands allow you to enable, disable, or show the status of the system hear tbeat.
Once a unit is configured and restar ted, the WAN link is up and the WAN IP address is established, the
hear tbeat will begin executing and sending its payloads (or establishing its connection in the case of TCP). A
special case is when the ip-ser ver address is on the LAN. In this case, the payloads will be routed to the LAN
side address, but only after the WAN link and WAN IP addresses have been established.
hear tbeat will begin executing and sending its payloads (or establishing its connection in the case of TCP). A
special case is when the ip-ser ver address is on the LAN. In this case, the payloads will be routed to the LAN
side address, but only after the WAN link and WAN IP addresses have been established.
If, at any time during the hear tbeat sequence, the link state changes – which means, for example, that there is
a layer 1 disconnect or a change in the IP layer parameters from a DHCP acquisition or a renegotiated PPP
session – the sequence will restar t. You can also restar t the sequence manually. In addition, in TCP mode once
the connection has been established, the sequence will be restar ted any time the remote ser ver closes it.
a layer 1 disconnect or a change in the IP layer parameters from a DHCP acquisition or a renegotiated PPP
session – the sequence will restar t. You can also restar t the sequence manually. In addition, in TCP mode once
the connection has been established, the sequence will be restar ted any time the remote ser ver closes it.
heartbeat protocol { udp | tcp }
show heartbeat protocol
show heartbeat protocol
These commands allow you to specify or show the protocol to be used for the system hear tbeat, udp or tcp.
The hear tbeat is a state machine:
■
If you select udp, there are no connections to the ser ver. If the ser ver address is known, it simply sends
the payloads in UDP.
the payloads in UDP.
■
If you select tcp, it tries to connect to the ser ver address, and keeps tr ying to connect for 20 attempts at
thir ty-second inter vals. If a connection is not established, it sleeps for a minimum of either 30 minutes, or
whatever is programmed as the sleep-time. See below.
thir ty-second inter vals. If a connection is not established, it sleeps for a minimum of either 30 minutes, or
whatever is programmed as the sleep-time. See below.
heartbeat client-port por t
show heartbeat client-port
show heartbeat client-port
These commands allow you to specify or show the client por t to be used for the system hear tbeat.
heartbeat interval time (in seconds)
show heartbeat interval
show heartbeat interval
These commands allow you to specify or show the hear tbeat inter val. in seconds.
heartbeat count count
show heartbeat count
show heartbeat count
These commands allow you to specify or show the hear tbeat count within the specified interval.
heartbeat sleep-time time (in seconds)
show heartbeat sleep-time
show heartbeat sleep-time
These commands allow you to specify or show the hear tbeat sleep time, in seconds, during which the system
will wait before retr ying a failed connection attempt, if tcp is the specified protocol.
will wait before retr ying a failed connection attempt, if tcp is the specified protocol.
heartbeat server port por t
show heartbeat server port
show heartbeat server port
These commands allow you to specify or show the hear tbeat ser ver por t number.