Справочник Пользователя для Netopia CLI 874

show interface t1 id line status

This command displays the line status on the specified T1 inter face.  This will display one of the following 
strings:

Red Alarm

   Yellow Alarm

   Blue Alarm

   Normal Operation

show interface t1 id loopback mode

This command displays the loopback mode of the specified T1 inter face.  This will display one of the following 
strings:

Layer 1 Activation Not Present

   Local Payload Loopback Enabled

   Remote Line Loopback Enabled

   Remote Payload Loopback Enabled

   Clear - No Loopback Enabled

show interface t1 id loopback status

This command displays the progress of the loopback test on the specified T1 inter face.  This will display one of 
the following strings:

Loopback Not Active

   PASS (xxxxx good, yyyyy bad packets)

   FAIL (xxxxx good, yyyyy bad packets)

#show interface t1 1 loopback status

   Loopback Not Active

   #interface t1 1 diagnostic mode send loopback

   #show interface t1 1 loopback status

   PASS (00255 good, 00000 bad packets)

   #show interface t1 1 loopback status

   FAIL (00000 good, 00256 bad packets)