Справочник Пользователя для Multi-Tech Systems MT3410ZLX
MultiMobile Owner’s Manual
38
The Modem Does Not Execute the Command Line
C:
Make sure you are typing
‘AT’ at the beginning
of command line (and hit Enter at the end).
C:
Make sure the modem is not in Data Mode.
Type
Type
+++ if necessary.
C:
Make sure your software is set to the same
COMx port as your MT3410ZLX.
COMx port as your MT3410ZLX.
The Modem Does Not Give a Response After an
AT Command Was Executed
AT Command Was Executed
C:
The echo and/or responses may be turned off
by the
by the
ATE0Q1 commands. Enable the AT&V1
to check Result Codes.
S:
Use
ATE1Q0 then Enter to change them back.
C:
Make sure the modem is in Command Mode
and not Data Mode when you type the AT
command.
and not Data Mode when you type the AT
command.
The Modem Gives an ‘ERROR’ Response After
an AT Command was Executed
an AT Command was Executed
C:
Make sure you did not type an invalid
command.
command.
C:
Make sure your command line is 40 characters
or less.
or less.
The Modem Goes Off-Hook and Disables the
Telephone Line.
Telephone Line.
C:
The modem may be set to auto-answer the
phone when it rings.
phone when it rings.
S:
Disable auto-answer by typing
ATS0=0 then
Enter at the command line.