Справочник Пользователя для Lucent Technologies 7820-0766-004
Setup
Checking status lights
Checking status lights
2-4
CellPipe™ 20 Series User’s Guide
Checking status lights
Observe the activity pattern of the lights at the front of the CellPipe units to verify that
they are connected properly.
they are connected properly.
Figure 2-3. Status lights
When all the cables are connected, verify that:
•
The
pwr
light comes on initially and remains on. If not on, make sure the power
supply is properly connected.
•
The
act
light blinks during any LAN traffic. Otherwise it remains off.
•
The
lnk
light is on if there is an Ethernet connection established. If not on,
check to make sure your Ethernet cable is properly connected.
•
The
wan
light blinks until a connection is established and then it remains on.
•
The
con
light is on only during the unit self-test.
Console setup
You need to set up a serial connection between the unit and your computer to access
the command-line interface and configure a CellPipe 20 Series unit.
the command-line interface and configure a CellPipe 20 Series unit.
You need a 9-pin RS-232 serial cable to connect to the CellPipe unit through the
console port.
console port.
You also need a terminal emulation program, such as HyperTerminal, PROCOMM
PLUS, Zterm, or any other program that supports VT100 terminal emulation, to open
a session directly with the unit.
PLUS, Zterm, or any other program that supports VT100 terminal emulation, to open
a session directly with the unit.