Справочник Пользователя для EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge

NOTE: This connection is required for setting up initial configuration 

information. After configuration is completed, the RS-232 null 
modem console cable shall be removed, and run a cross-over 
Ethernet cable from Data Input Port to PC, or a straight Ethernet 
cable to LAN connection, e.g. Hub. 

 
Step 5

Attach

 

one straight Ethernet cable to the Power & Data Output 

Port on the Inline Power Injector(refer to 

).  

 
Step 6

Plug the other end of the straight Ethernet cable to the Ethernet 
Port (refer to 

) on the Wireless client bridge.  

 
When the Wireless client bridge receives power over the Ethernet cable, 
the Wireless client bridge will start its boot sequence and the Active LED 
on the Inline Power Injector will light up. 
 
You can configure the Wireless client bridge via HTML browser, such as 
Microsoft Internet Explorer or Netscape Navigator from a remote host or 
PC. 
 
 
 
 
 

 

The Wireless client bridge can be configured into two operation roles, 
including Wireless Client Bridge and Wireless Client Router. 
 
The Wireless client bridge is shipped with default configuration to function 
as a client bridge between an Ethernet and Wireless network by attaching 
Wireless client bridge to the wired LAN simply. If user would configure 
Wireless client bridge, please refer to the following procedures. 
 

 
This section describes a five-step configuration procedure to setup 
Wireless client bridge workable upon your topology requirement. 
 
Step 1  Select an operation mode for Wireless client bridge on the web 

page “/General Config/System/”, and click FINISH to refresh this 
page. 

 

Step 2  Modify the factory-default parameters on the web page “/General 

Config/System/”, and click FINISH to save the changes. 

 
Step 3  Modify the factory-default parameters on the web page “/General 

Config/Wireless/”, and click FINISH to save the changes. 

 
Step 4  (Optional) Modify other parameters on the web page “/General 

Config/”, and click FINISH to save the changes. 

 
Step 5  Move to page “/Utility/Administration/”, select the            Save 

then Restart and then click FINISH to take effect on the previous 

configuration changes.