Справочник Пользователя для IBM 4986B LanProbe
Introduction
LanProbe Overview
11
Figure 1-3: Front Panel LEDs
CONFIG Button
The CONFIG button is used to configure LanProbe from a terminal or to restart
the probe. The CONFIG button is recessed and located on the back of the probe
near the RS-232C connector. You will need to use a narrow, pointed object (like a
pen) to press the CONFIG button.
the probe. The CONFIG button is recessed and located on the back of the probe
near the RS-232C connector. You will need to use a narrow, pointed object (like a
pen) to press the CONFIG button.
To configure LanProbe using a local terminal (or PC emulating a terminal),
connect a terminal to LanProbe using a null modem cable and push the CONFIG
button to display LanProbe’s Main Menu. This operation is described in Chapter 2
“Local Terminal Configuration”.
connect a terminal to LanProbe using a null modem cable and push the CONFIG
button to display LanProbe’s Main Menu. This operation is described in Chapter 2
“Local Terminal Configuration”.
You can restart the probe (with a warm start or cold start) using the CONFIG
button. These functions are described in Chapter 5 “LanProbe Operation”.
button. These functions are described in Chapter 5 “LanProbe Operation”.
Included Parts
The following items are included with your :Agilent 4986B Ethernet LanProbe: