Справочник Пользователя для IBM 4986B LanProbe
Bootp Server Configuration
Probe Configuration Using a Bootp Server
53
Probe Configuration Using a Bootp Server
You can use a Bootstrap Protocol
(Bootp*) server to load LanProbe’s IP
configuration. This method requires that a Bootp server maintains a file
containing client configuration information, maps from MAC addresses to IP
addresses, and responds to requests from clients. You can configure the probe
from an HP-UX, Solaris, or MS-DOS system acting as a Bootp server. The system
that is operating as the Bootp server must be connected to your network. Table 4-2
on page 54 shows the minimum requirements for a Bootp server operating on HP
9000, Sun SPARC, and PC systems.
containing client configuration information, maps from MAC addresses to IP
addresses, and responds to requests from clients. You can configure the probe
from an HP-UX, Solaris, or MS-DOS system acting as a Bootp server. The system
that is operating as the Bootp server must be connected to your network. Table 4-2
on page 54 shows the minimum requirements for a Bootp server operating on HP
9000, Sun SPARC, and PC systems.
Before you can use the Bootp server, you must edit the bootptab file to configure
the required LanProbe parameters. Refer to “Configuring the Bootptab File” on
page 65 for more information.
the required LanProbe parameters. Refer to “Configuring the Bootptab File” on
page 65 for more information.
LanProbe’s MAC address is twelve characters long and is printed on a tag on the
back of the probe. You must determine the IP Address, Default Gateway IP
Address, and Subnet Mask from the network.
back of the probe. You must determine the IP Address, Default Gateway IP
Address, and Subnet Mask from the network.
To allow LanProbe to use a Bootp server that is not on the same subnet, the router
involved must support Bootp Relay (the transfer of a Bootp request). For example,
if you have multiple LanProbes that you want to configure from a single Bootp
server, be sure that the routers in the path between your Bootp server and the
LanProbes support Bootp Relay. Otherwise, you will need to operate the Bootp
server on the same subnet as your LanProbes. You can configure multiple
LanProbes on one subnet and then place them on their respective segments.
involved must support Bootp Relay (the transfer of a Bootp request). For example,
if you have multiple LanProbes that you want to configure from a single Bootp
server, be sure that the routers in the path between your Bootp server and the
LanProbes support Bootp Relay. Otherwise, you will need to operate the Bootp
server on the same subnet as your LanProbes. You can configure multiple
LanProbes on one subnet and then place them on their respective segments.