Справочник Пользователя для RAD Data comm IPmux-11

Chapter 4  Configuration 

Installation and Operation Manual 

4-20 

Configuring IPmux-11 for Operation 

IPmux-11 Ver. 2.00 

IPmux-11 supports one bundle that can include up to 31 E1 or up to 24 T1 
timeslots. The bundle can be connected to any bundle of the TDMoIP device that 
operates opposite IPmux-11. Currently, TDMoIP traffic is sent and received via the 
network port only.  

 

To configure bundle connection: 
1.  From the Configuration menu, select Connection. 

The Connection menu appears (see 

2. Select DS0 bundle. 

The DS0 Bundle menu appears (see 

). 

3.  From the DS0 Bundle, assign timeslots to the current bundle (1) by selecting a 

timeslot and choosing 1 (assigned) or 0 (not assigned). 
You can assign all timeslots to the current bundle at once by typing E. 
You can cancel assignment of all timeslots to the current bundle at once by 
typing L. 

4.  From the Connection menu, configure the PSN Type: 

 

UDP/IP (bundle encapsulation is UDP/IP) 

 

MPLS/ETH (bundle encapsulation is MPLS (Multi-Protocol Label Switching) 
/ Ethernet) 

 

 

5.  From the Connection menu, select Bundle connection. 

The Bundle Connection menu appears (see 

 and 

 

 

6.  From the Bundle Connection menu, configure the following (if it appears in 

the menu): 

 

Destination IP Address (IP address of the destination device): 0.0.0.0 to 
255.255.255.255. 

 

Outbound Label Tagging: 

 

Enable (Outbound labels are enabled) 

 

Disable (Outbound labels are disabled) 

 

Outbound tunnel label (MPLS transmit label): 0–1048576 

 

Outbound EXP bits (MPLS label exp bits): 0–7 

 

Inbound label tagging: 

 

Enable (Inbound labels are enabled) 

 

Disable (Inbound labels are disabled) 

 

Inbound tunnel label (MPLS receive label): 0–1048576