Справочник Пользователя для Lantronix 1-T2
Installation
MSS Components
2 - 1
2 - Installation
This chapter covers the installation of the MSS in an Ethernet network
and the attachment of a serial device. Basic knowledge of networking
installation is assumed. Read this section completely before continuing.
and the attachment of a serial device. Basic knowledge of networking
installation is assumed. Read this section completely before continuing.
2.1 MSS Components
The MSS front panel has a male DB25 serial connector. The following Þgure
shows an MSS1 front panel. The MSS100 rear panels is more narrow.
shows an MSS1 front panel. The MSS100 rear panels is more narrow.
Figure 2-1:
MSS1 Front Panel
The MSS rear panel has an RJ45 Ethernet connector, a BNC Ethernet
connector (MSS1-T2 only), a reset button, and a power connector. The
following Þgure shows an MSS1 rear panel. The MSS100 rear panels is more
narrow, and does not include a BNC connector.
connector (MSS1-T2 only), a reset button, and a power connector. The
following Þgure shows an MSS1 rear panel. The MSS100 rear panels is more
narrow, and does not include a BNC connector.
Figure 2-2:
MSS1 Rear Panel
NOTE:
When the reset button is pressed and held during the power up
and boot procedures, the MSS returns to its factory default
configuration.
and boot procedures, the MSS returns to its factory default
configuration.
Serial
DB25 Serial Port
10BaseT
6V DC
Reset
10Base2
Power Connector
Reset Button
BNC Ethernet Port
RJ45 Ethernet Port
(MSS1-T2 only)