Справочник Пользователя для Printronix Integrated Network Interface Card
Chapter 5
Unix NIC Configuration
112
3.
Under the Subnet Mask heading, enter the NIC subnet mask.
NOTE: If you would like to communicate with the NIC from across
routers, you will need to fill in an entry within the “Routing”
section. Please see “Communicating Across Routers” on
page 114 for further details.
section. Please see “Communicating Across Routers” on
page 114 for further details.
4.
Click the Submit button when done and physically repower the
print server to make sure the new settings are in effect.
print server to make sure the new settings are in effect.
Using RARP
RARP allows you to dynamically assign an IP address to the NIC
upon bootup. To configure the NIC with its TCP/IP settings using
RARP:
upon bootup. To configure the NIC with its TCP/IP settings using
RARP:
1.
On your RARP server, make an entry in the /etc/ethers file for
the NIC.
the NIC.
Syntax:
ethernetaddress NICIPaddress
Example:
00:08:96:07:00:60 192.75.11.9
2.
Start the RARP daemon on the RARP server if not already
running. If it is running, send an HUP signal to it with the kill
command:
running. If it is running, send an HUP signal to it with the kill
command:
Syntax:
kill -HUP pid
where pid is the process ID of the RARP daemon.
3.
Power on the NIC so that it immediately sends out an RARP
request. Wait one minute to allow the address assignment
process to complete. You should see the STAT LED on the NIC
interface slow down, indicating it knows about an IP address to
use.
request. Wait one minute to allow the address assignment
process to complete. You should see the STAT LED on the NIC
interface slow down, indicating it knows about an IP address to
use.