Справочник Пользователя для Printronix Integrated Network Interface Card
Chapter 8
Configuring On AS/400 As An IPDS Printer
168
Configuring PSF/400 For IPDS On V3R7 And
Above
Above
To configure IPDS on AS/400 V3R7 and above, use the following
commands:
commands:
•
CRTPSFCFG
(Optional)
•
CRTDEVPRT
Configuring AFP With CRTPSFCFG On V3R7 Or
V4R1 (Optional)
V4R1 (Optional)
New for V3R7 is the ability to specify three TCP/IP-related
parameters for PSF in a printer device description: RMTLOCNAME,
parameters for PSF in a printer device description: RMTLOCNAME,
PORT
, and ACTTMR. In V3R2, CRTPSFCFG, which replaced
WRKAFP2
, was used to specify these same parameters, along with
other parameters. In V3R7 and higher, these three parameters are
ignored when specified in a PSF configuration object, since they
are specified in a printer device description. However, you may
wish to use a PSF configuration object to specify other parameters,
such as IPDS passthrough and so on.
ignored when specified in a PSF configuration object, since they
are specified in a printer device description. However, you may
wish to use a PSF configuration object to specify other parameters,
such as IPDS passthrough and so on.
The PSF configuration object created with this command is used by
PSF/400 when printing IPDS files only if the object is specified with
the USRDFNOBJ parameter in the printer device description.
PSF/400 when printing IPDS files only if the object is specified with
the USRDFNOBJ parameter in the printer device description.
To configure AS/400 for IPDS printing on V3R7 or V4R1:
1.
At the AS/400 command line, enter a command in the form:
CRTPSFCFG PSFCFG(AFP/printer_typeNETPRT)
IPDSPASTHR(*YES) RLSTMR(*SEC15)
TEXT(‘printer_type NETWORK PRINTER’)
TEXT(‘printer_type NETWORK PRINTER’)
where printer_type
(e.g., T5000, P5000, L5520) is the
model of your printer.