Справочник Пользователя для Printronix Integrated Network Interface Card
Configuring PSF for IPDS On V4R2 And Above
173
d.
Device Model (MODEL)
Specify 0
e.
LAN Attachment (LANATTACH)
Specify *IP
f.
Port Number (PORT)
Specify 5001
g.
Font (FONT)
Enter an appropriate value.
h.
Form Feed (FORMFEED)
Specify *CONT
i.
Activation Timer (ACTTMR)
This value specifies the number of seconds that PSF/400
waits for a printer to respond to an activation request. If
only one system is using the printer, use the default value
(170 seconds). If more than one system is using the printer,
specify *NOMAX, which causes PSF/400 to wait indefinitely
for a response to an activation request.
waits for a printer to respond to an activation request. If
only one system is using the printer, use the default value
(170 seconds). If more than one system is using the printer,
specify *NOMAX, which causes PSF/400 to wait indefinitely
for a response to an activation request.
j.
Remote Location (RMTLOCNAME)
Enter the IP address or hostname of the printer.
k.
User-Defined Object (USRDFNOBJ)
To use a PSF configuration object, specify its name and
library here. This object type must be *PSFCFG. For V3R7
and higher, a single PSF configuration object may be
referenced by multiple device descriptions, if required.
library here. This object type must be *PSFCFG. For V3R7
and higher, a single PSF configuration object may be
referenced by multiple device descriptions, if required.
Configuring PSF for IPDS On V4R2 And Above
To configure IPDS on the iSeries V4R3, use the following
commands:
commands:
•
CRTDEVPRT
•
CRTPSFCFG (Optional)