Справочник Пользователя для Printronix Integrated Network Interface Card
Chapter 8
Configuring On AS/400 As An IPDS Printer
176
Release timer (RLSTMR)
Specifies the amount of time to wait before a session or dialog is
released without terminating the writer. The ACTRLSTMR
parameter specifies when this timer is to be activated. Set the
parameter to a value at least equal to the TIMEOUT value on the
printer. Printronix recommends *SEC15.
released without terminating the writer. The ACTRLSTMR
parameter specifies when this timer is to be activated. Set the
parameter to a value at least equal to the TIMEOUT value on the
printer. Printronix recommends *SEC15.
Page size control (PAGSIZCTL)
Specifies if the page size (forms) is set by PSF. Usually set to
*YES.
*YES.
Remote Location name or address (RMTLOCNAME)
Enter the IP address or hostname of the printer.
Configuring PSF with CRTDEVPRT On V4R2
and Above
and Above
This section describes how to create a printer device description.
1.
At the iSeries command line, enter a command in the form:
Only use the USRDFNOBJ parameter if it was defined in the
previous procedure.
previous procedure.
A completed screen looks like the example shown in Figure 46.
CRTDEVPRT DEVD(P7000) DEVCLS(*LAN) TYPE(*IPDS) MODEL(0)
LANATTACH(*IP) AFP(*YES) PORT(5001) FONT(11)
FORMFEED(*CONT) RMTLOCNAME(‘128.9.12.134’)
FORMFEED(*CONT) RMTLOCNAME(‘128.9.12.134’)
USRDFNOBJ(AFP/NETPRTP7000 *PSFCFG)
TEXT(‘Printronix P7000 NETWORK PRINTER’)